Project 2.01 — rpi’s GPIO Pins + oF WiringPi Library

Assignment — pvirasat @ 11:00 am

This is my first time working with a raspberry pi and I am hooked! This project demonstrates the basic working of the GPIO Pins on the raspberry pi, using openFrameworks library ‘WiringPi’. I used three buttons as inputs to control the direction, size and color of a circle on the screen.

It took me a while to get in the flow of accessing the raspberry pi through ssh, but after I got that working the rest wasn’t too bad. I worked on the hardware and software separately and made sure that everything worked on its own before integrating them. It was definitely a good introduction to raspberry pi and openFrameworks.

project2.01

DSCF3962

project2.01

DSCF3959

0 Comments »

No comments yet.

RSS feed for comments on this post. TrackBack URI

Leave a comment

This work is licensed under a Creative Commons Attribution-Noncommercial-Share Alike 3.0 Unported License.
(c) 2020 Making Things Interactive | powered by WordPress with Barecity